Steris Amsco 3052

24-Hour Quotes

Pricing up to 50% below the cost of new,
with service and warranty included.
Download Specifications

Steris Amsco 3052 Features

The Steris Amsco 3052 Single-Chamber Washer/Disinfector features an integrated touchscreen and is used for cleaning and intermediate-level disinfection of soiled reusable utensils, trays, bedpans, and urinals. This Steris Amsco 3052 can also be used for rubber and plastic goods, simple hard-surfaced rigid surgical instruments, such as forceps and clamps, and other similar and related articles found in a healthcare facility.

  • Color touch-screen microprocessor control system.
  • Audible warning system.
  • Space saving, power vertical sliding doors.
  • Eight factory-loaded cycles.
  • Chamber illumination by long-life, energy-efficient LEDs.
  • Compact and space-saving footprint.
  • Conforms to seismic building code requirements.

Steris Amsco 3052 Specifications

Dimensions

  • Height: 80″ (203.2 cm)
  • Width: 42″ (106.7 cm)
  • Length: 31″ (78.7 cm)
  • Load Height: 31″ (78.7 cm)

Utility Requirements

  • Hot, Cold, and Pure Water; Steam; Condensate Return: 1/2 NPT
  • Air: 1/8 NPT
  • Ventilation: 3″ (7.6 cm) O.D.
  • Drain: Recommended minimum 4″ (10.2 cm) floor drain. An 8 x 8″ (20.4 x 20.4 cm) floor sink is also recommended.

Safety Features

  • Vertical chamber doors are equipped with an obstruction sensor to detect any door obstruction. If an obstruction is present the door automatically opens.
  • The washer/disinfector is equipped with a safety lockout feature so a cycle cannot start unless the door is fully closed.
  • A door interlock feature is provided to prevent cross-contamination. The door interlock feature allows only one door to be opened at a time whenever power is on.
  • Safety spot pushbuttons, one on the load and one on the unload side, automatically stop all unit operations when pressed.
  • Building electrical supply disconnect switch must be used to shut off power to the unit before servicing.

Wash Chamber Construction

  • 16-gauge, #3-4 L stainless steel, argon-welded and polished.
  • The chamber is of sanitary-type design (horizontal fixed surfaces are sloped, overlapping metal sheets) for complete drainability and to reduce hard-to-clean locations.
  • Single-walled, insulated construction of the chamber exterior reduces heat loss and noise level in the work area.
  • Rotary spray assemblies are positioned at the top and the bottom of the chamber, each measuring 24-3/8″ (62 cm) long to reach all load surfaces, Spray assemblies are easily removable without tools to aid in cleaning and maintenance.
  • 3-W LED light mounted within an explosion/vapor-proof enclosure, illuminates chamber interior.

System Drying

  • The drying system is manifold and circulates HEPA-filtered air through piping, accessories, and chamber for 1 to 60 minutes at low temperatures of 108°F (82°C) or 1 to 30 minutes at a high temperature of 240°F (115°C).
  • The system includes a cold water condenser.
  • The system includes a 3hp (2.2 kW), blower and three electric heaters totaling 11.4kW.
  • The system heats and maintains the chamber to 180-240°F (82-115°C). No additional ductwork is required.

Pure Water Rinse Supply

  • Washer/disinfector is equipped with a Pure Water Stainless-Steel Supply Valve.
  • Pure water from the facility is sprayed over the load under pump pressure for 15 seconds (adjustable from 15 seconds to 15 minutes.)
  • Up to four Pure Water Rinse treatments can be selected per cycle with recirculated water.
  • Pure water can be used for thermal disinfection stage and is heated to 194°F (90°C) using either steam or electric heaters.

Drain Discharge Cool Down

  • This feature assures water drained at the end of each phase, from the chamber sump to the building drain system, does not exceed 140°F (60°C).
  • If the water temperature in the sump is higher than 140°F (60°C), cold water is automatically added to reduce the temperature of the water discharged into the building drain system.

Sump

  • Constructed of #304 L Stainless steel with 9.5 gal (36 L) capacity.
  • The removable stainless-steel filter in the chamber sump prevents debris from entering the pump and piping system.
  • The heating coil at the bottom of the wash chamber (sump) raises and maintains water temperature up to 180°F (82°C) during the Wash phase and up to 194°F (90°C) during the Thermal Rise phase.

Chemical Injection Pumps

  • Pumps are optimized to use Prolystica Ultra Concentrate chemicals. Each ultra-concentrated product is 10 times more concentrated than an equivalent traditional product; so 10 times less chemical is injected per cycle.
  • The washer/disinfector comes with one enzyme and one detergent injection peristaltic pump which automatically add a selected quantity of chemical from 1/40 to 2oz/gal (0.2 to 16 mL/L)
  • One injection peristaltic pump is dedicated to automatically adding a selected quantity of lubricant during the Thermal Rise phase.
  • Pumps are positioned near chemical containers.

Microprocessor Control System

  • Equipped with a 5.7″ (14.5 cm) touch-screen customer interface that is mounted at eye level beside the chamber door on both sides of the unit.
  • Locking program cycle parameters with an access code.
  • Service mode for preventive maintenance testing and facilitate troubleshooting.
  • Built-in service diagnostic program to permit system calibration and verification of component operations.
  • Security lock-out feature that enables programs and temperatures to be locked and unchangeable without the proper access code.
  • Equipped with an audible warning system.

Refurbished Steris Amsco 3052 Washer and Disinfactor

Soma Tech Intl offers Steris Amsco 3052 Washers and Disinfectors up to 50% below OEM prices with the same service and warranty as new. The Steris Amsco 3052 is not only technically refurbished but also cosmetically refurbished to make it work and look like new. When the refurbishing process starts on the Steris Amsco 3052, it is carefully inspected and tested by our own in-house biomedical engineers who are highly skilled and certified to work on washers and disinfectors. If necessary, parts are replaced to make sure that all aspects of the Steris Amsco 3052 are functioning properly. Once everything is in working order, the unit is calibrated back to the original engineering manufacturer’s specifications. This ensures that the unit is working the same way that it originally left the manufacturer. After the Steris Amsco 3052 is working like new it undergoes a special cosmetic restoration process. The Steris Amsco 3052 is cleaned, minor scratches and dents are repaired, it’s painted, and new decals are replaced if necessary. After this strenuous refurbishing process, the unit functions and looks like new. Soma Tech Intl is ISO 13485 certified and ensures that the best quality is given to all capital medical equipment that they sell. Before the Steris Amsco 3052 is labeled patient-ready and packed up for shipment, it goes through one last quality control test that makes sure all aspects are again working as they should. If you are looking to buy refurbished Steris Amsco 3052 disinfectors contact soma at [email protected] or call us at 1-800-GET-SOMA.

Soma Tech Intl is also actively looking to purchase a Steris Amsco 3052. If you or your facility is looking to sell your Steris Amsco 3052, be sure to contact Soma Tech Intl. Soma has a dedicated and experienced purchasing department that helps you through the entire process. Selling your used or pre-owned Steris Amsco 3052 to Soma Tech Intl takes out the middle man in the equation. This also ensures that your medical facility gets top dollar for your equipment. Soma is 100% HIPPA compliant and makes sure that your equipment gets to our facility in the same condition that it left yours. Soma Tech Intl also gives the option for trade-in credit on your medical equipment. If you have medical equipment you would like to sell to Soma, send us a message here!

Banner

Questions about our Autoclaves, Sterilizers, Washers, or Disinfectors?

Soma Tech Intl offers a wide range of autoclaves. If you have any questions about any of our Autoclaves, Sterilizers, Washers, and Disinfectors or need a quick quote, call us and one of our knowledgeable sales representatives will help you.

Looking to sell your Autoclaves, Sterilizers, Washers, or Disinfectors? Soma ensures your facility gets top dollar for your equipment and also gives the option for trade-in credit.

1-800-GET-SOMA
Contact Us