Physio-Control Lifepak 9

Quotes in less than 24 hours Download Specifications

Physio-Control Lifepak 9 Features

The Physio-Control Lifepak 9 is a defibrillator/monitor with a microprocessor. The Lifepak 9 defibration system offers a simple, user-friendly operation. The Lifepak defibrillation system features both high and low-energy selections, cardioscope, non-invasive pacing, and 3-lead and 5-lead ECG monitoring. The Physio-Control Lifepak 9 also features an adaptor that allows for hands-free defibrillation. The microprocessor determines how many joules of energy are required for defibrillating a patient. Allowing the system to readjust to low battery power or lower voltage uses, with paddles for both adult and pediatric patients.

  • Microprocessor-based unit with optimal pacing
  • Can operate on either AC power or internal battery power
  • Built-in recorder and 3-5 lead ECG monitoring
  • CRT Monitoring can display heart rate and alarms
  • Front panel push buttons provide controls for most functions

 

Physio-Control Lifepak 9 Specifications

Dimensions

  • Height: 35.2 cm (13.9 in)<//li>
  • Width: 29.7 cm (11.7 in)
  • Depth: 31cm (12.2 in)
  • Weight: 12.7 kg ( 28 lbs)

General specifications

  • Power Cord Length: 3m (10 Ft)
  • Standard Paddle Electrode area: 82 square cm
  • AC Input Option: 120 or 240 Vac nominal line voltage without adjustment. 50 or 60Hz, with adjustment in the SET UP menu.
  • Battery type: Sealed lead-acid, 16 Vdc nominal, 3 Amp-hour
  • low battery indicator: Advises operator to connect AC power.
  • Battery Charge Indicator: Illuminates when the battery is charging.
  • Battery Charge Time: 24 hours to full capacity. <?li>
  • Service Indicator: Indicates self-diagnostic routines have detected improper operation requiring service attention.
  • Power Consumption: 160 Watts maximum while monitoring with recorder ON and defibrillator charging.

ECG Monitor

  • ECG Lead Selections: Std, Paddles, I, II, III
  • Input: Isolated ECG via QUIK-LOOK® defibrillator paddles, FAST-PATCH® disposable defibrillation/ ECG electrodes, or 3-lead patient cable.
  • Patient Cable Length: 4.0m (13 ft) total length; 3.1m cable (10 ft) with 0.9m leads (3 ft)
  • Common Mode Rejection: 100dB minimum with respect to chassis ground and 65dB minimum with respect to isolated ground, when measured at 60Hz. Common mode range for patient cable input = 10 Volts peak with respect to isolated ground.
  • Monitor Display Size:102mm (4 in) wide x 76mm (3 in) tall, non-fade
  • Sweep Speed: 25mm/second
  • Frequency Response: Non-diagnostic
  • ECG Leads:1.0 to 40Hz (-3dB) <?li>
  • Paddles: 2.2 to 20Hz (-3dB)
  • ECG Size: Adjusts amplitude of ECG trace on monitor and strip chart recorder. <?li>
  • Heart Rate Meter: 3-digit readout displays rates from 20 to 300 bpm. Heart rates outside this range do not yield valid systole tones or heart rate displays. Heart Rate Alarm: User-selectable alarm limits. Three high/low settings (150/40, 120/60, 160/90). Other limit options are available via the SET UP menu.
  • 1 mV Cal: A momentary pushbutton switch on the rear panel simulates a 1 mV signal pulse to the ECG input.
  • ECG Output:1 Volt/mV

Defibrillator

  • Defibrillator Waveform: 5-millisecond monophasic pulse (Edmark)
  • Energy Select:
    • External Paddles: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 20, 30, 50, 100, 200, 300, 360 Joules
    • Internal Paddles: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 20, 30, 50 Joules
  • Charge Controls: Independent momentary push-button controls on the front panel and APEX paddle.
  • Paddle Cord Length:3m (10 ft)
  • Charge Indicators: Flashing lamps on the paddle and front panel pushbutton along with increasing stored energy display indicate a charge in progress. Upon full charge, the energy available is displayed on the monitor and charge completed tone sounds.
  • Charge Time: Charge to 360 Joules in less than 10 seconds with a fully charged battery.
  • SYNC: Synchronizes defibrillator pulse to patientgenerated QRS complex.
  • SYNC Indicator: The inverted triangle marker on the displayed ECG waveform identifies the synchronizer trigger point with respect to the patient’s QRS complex.

Thermal Array Recorder

  • Paper Size: 50mm wide x 30m (100 ft) <?li>
  • Paper Speed: 25mm/second <?li>
  • Delay: ECG prints 8 seconds after first appearing on the monitor.
  • Frequency Response: Non-diagnostic. Diagnostic available via SET UP menu.
  • ECG Leads (non-diagnostic): 1.0 to 40Hz (-3dB)
  • ECG Leads (diagnostic): 0.05 to 100Hz (-3dB)
  • Paddles: 2.2 to 20Hz (-3dB)
  • Annotation: Time, date, ECG lead, ECG gain, heart rate, defibrillation parameters, test load discharges
  • CODE SUMMARY Critical Event Record: Digitally stored record of ECG and device parameters

Environmental

  • Atmospheric Pressure: 797mmHg to 500mmHg (-570 to 11000 ft)
  • Relative Humidity: <?li>
    • 0 to 95% (non-condensing) at 0 to 34°C
    • 0 to 80% (non-condensing) at 35 to 45°C
  • Temperature Range: 0 to 45°C operating -30 to 65°C storage
  • All specifications at 20°C unless otherwise stated.
Banner

Questions about our Defibrillators?

Soma Tech Intl offers a wide range of defibrillators. If you have any questions about any of our defibrillators or need a quick quote, call us and one of our knowledgeable sales representatives will help you.

Looking to sell your defibrillators? Soma ensures your facility gets top dollar for your equipment and also gives the option for trade-in credit.

1-800-GET-SOMA
Contact Us