Reliance 444 Series Washer

Reliance 444 Washer Features

The Reliance 444 Single-Chamber Washer/Disinfector, a mechanical washer/disinfector, is equipped with an Eagle® 3000 Stage 3TM control system. The washer/disinfector is designed with seven factory set cycles: Instruments, Gentle, Utensils, Glassware, Plastic Goods, Anesthesia/Respiratory Goods, and Decontamination. Three additional cycles are available for customized programming to meet specific operating requirements. Each preprogrammed cycle is equipped with Pre-Wash, Wash, Rinse, and Thermal Rinse (including Drain Discharge Cool Down) phases. The washer/disinfector is built to seismic design and includes a vented system and interior chamber light. The washer/disinfector offers both manifolded and non-manifolded washing and a power vertical sliding door, in a single- or double-door configuration.

Reliance 444 Washer Specifications

General

• Vertical sliding power door(s) is constructed of tinted, tempered glass with stainless-steel trim to allow the operator to
• view the chamber with the door closed. While a cycle is in progress, glass door remains cool to the touch.
• Sliding door(s) is configured for power door operation.
• Door is opened and closed automatically using touch pads on the control panel, located on the same side of the washer/disinfector as the door being operated.
• Each power door includes a safety sensor to retract the door if an obstruction is detected in the doorway. If a power failure occurs, door(s) can be opened manually.
• The manual access handle is located on the top edge of the door and concealed behind the top service panel. If double power doors are ordered, a door interlock feature is provided to help prevent cross-contamination.
• Stainless-steel pump is powered by a dual-speed motor.
• High pump speed provides the equivalent capacity of a 7.5 HP (5.6kW) motor, 240 U.S. gal/min at 70 ft (910 L/min at 21.3 m) head pressure. Low pump speed provides the equivalent capacity of a 2 HP (1.4 kW) motor, 90 U.S. gal/min at 25 ft (341 L/min at 7.62 m) head pressure. Pump impeller is mounted directly on this motor shaft and does not require additional bearings.