Steris Medivators DSD-201

24-Hour Quotes

Pricing up to 50% below the cost of new,
with service and warranty included.
Download Specifications

Steris Medivators DSD-201 Features

The automated endoscope reprocessor features two fully independent and asynchronous reprocessing basins for high-volume, quick endoscope turnaround. The Steris Medivators DSD-201 has user-programmable reprocessing cycles and an enhanced sensor package for continuous monitoring of all cycle parameters.

  • Fast cycle time for quick endoscope turnaround.
  • Two basins for simultaneous or independent cycles.
  • Cycle parameters continuously monitoredLeak test ensures endoscope protection throughout the cycle.
  • Automated alcohol flush and air dry.
  • Audible and visual alarms for reprocessing cycle deficiency.
  • Assures patient and operator safety.
  • Cycle customization meets specific reprocessing needs.

 

 

Steris Medivators DSD-201 Specifications

Dimensions

  • Chassis Dimensions (height x width x depth): 46”x36”x21” (117x91x53cm)
  • Height with lid open: 64 inches (162.5 cm)
  • Weight: 400lbs (181kg)

Operating Conditions

  • Altitude: <15,000 feet (4,572m)
  • Humidity: 20% to 80%, non-condensing
  • Temperature: 80°F ± 20° (27°C ± 10°)

Electrical Requirements

  • 230 VAC 50/60 Hz, 6A 1f
  • 120 VAC 60 Hz, 12A 1f

Water Requirements

  • Potable water from the building (cold water supply).
  • 35-40psi (2.4 – 2.75bar) at regulator.
  • Water temperature maximum: 110°F (43°C)

Capacities

  • Disinfectant reservoir: 15 liters
  • Basin: 11 liters
  • Alcohol and detergent reservoir: 800ml each

General

  • Power Cord: Hospital-grade 8 feet (2.4m)
  • Mains Supply Voltage Fluctuations: Not to exceed ±10% of the nominal voltage Installation Over Voltage Category: II
  • Classification: I, Ordinary Protection
  • Rinse Water Consumption: Approx. 10 gallons (39 liters) per cycle
  • Designed for Use: Indoor
  • Environmental Rating: Standard
  • Pollution Degree: 2
  • Mode of Operation: Continuous
  • Degree of Mobility: Stationary
  • Waste Drain: The reprocessor drain is 25 inches (60cm) above the floor. Because the reprocessor uses a gravity system there must be at least a 3-inch (25mm) drop from the reprocessor over 36 inches (30cm) for proper draining
  • Disinfectant Compatibilities: Contact your local distributor for compatible reprocessing chemicals
  • Internal Heater: Ambient temperature to 125°F (52°C)

 

Banner

Questions about our Endoscope Reprocessors?

Soma Tech Intl offers a wide range of endoscope reprocessors. If you have any questions about any of our endoscope reprocessors or need a quick quote, call us and one of our knowledgeable sales representatives will help you.

Looking to sell your endoscope reprocessors? Soma ensures your facility gets top dollar for your equipment and also gives the option for trade-in credit.

1-800-GET-SOMA
Contact Us